Wolfvision VZ-C32 User Manual Bedienungsanleitung PDF herunterladen (Seite 17)

DVI-I Port

1 - T.M.D.S. Data2- 9 - T.M.D.S. Data1- 17 - T.M.D.S. Data0-

2 - T.M.D.S. Data2+ 10 - T.M.D.S. Data1+ 18 - T.M.D.S. Data0+

3 - T.M.D.S. Data2/4 Shield 11 - T.M.D.S. Data1/3 Shield 18 - T.M.D.S. Data0+

4 - T.M.D.S. Data4- (*) 12 - T.M.D.S. Data3- (*) 19 - T.M.D.S. Data0/5 Shield

5 - T.M.D.S. Data4+(*) 13 - T.M.D.S. Data3+ (*) 20 - T.M.D.S. Data5- (*)

6 - DDC Clock 14 - +5V Power 21 - T.M.D.S. Data5+ (*)

7 - DDC Data 15 - Ground (return for +5V, 22 - T.M.D.S. Clock+

8 - Analog Vertical Sync HSync and Vsync) 23 - T.M.D.S. Clock-

C1 - Analog Red 16 - Hot Plug Detect 24 - Analog Vertical Sync

C4 - Analog Horizontal Sync C2 - Analog Green C3 - Analog Blue

C5 - Analog Ground *...not used

(analog R, G & B return)

Pin 24

Pin 8

Pin 1

Pin 9

Pin 17

The Ceiling Visualizer is fitted with an automatic lamp changer.

If one lamp fails, there is no need to replace it immediately, as the automatic lamp changer

automatically switches to the second (spare) lamp. When the unit changes lamps there is

an on-screen message saying: "Changing lamp".

When switching on the unit the Visualizer checks if both lamps are working. If one lamp fails

there will be an on screen message for a couple of seconds displaying "Lamp x blown".

This prevents a user from forgetting to change a defective lamp.

Automatic Lamp Changer

If the unit gets too hot (improper ventilation or air extraction) a built in thermostat will switch

off the light of the Visualizer. Verify that proper ventilation and air extraction is available and

allow the unit to cool.

Thermostat

In some rooms the 3 built-in infrared receivers of the Ceiling Visualizer may not be enough.

In this case connect the supplied external infrared receiver to the IR-sensor plug (#17) and

position the IR-sensor somewhere on the ceiling (or in the room) where the users normally

point the remote control at.

IMPORTANT

External Infrared (IR) Sensor

Lightbox (optional)

When a lightbox is used, the top light of the Visualizer should be switched off

with the assigned PRESET key (LIGHT).

Using a bottom light has the disadvantage that the Synchronized Lightfield of the top light

no longer marks the pick-up area of the built-in camera.

The recommended lightbox for the Ceiling Visualizer is the WolfVision Lightbox LB-38.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Keine Kommentare

Wolfvision VZ-C32 User Manual Bedienungsanleitung Seite 17